![]() If everything looks good, go ahead and take it for a test drive! How Much Transmission Fluid Does a Torque Converter HoldĪ torque converter is a fluid coupling that connects the engine to the transmission. You’ll need about 10 quarts for a complete flush and fill. Allow all of the old fluid to drain out.Ģ) Remove the old filter and install a new one.ģ) Refill the transmission with fresh fluid. ![]() Here’s how to change the fluid and filter on a 4L60E transmission:ġ) Jack up the car and remove the drain plug from the bottom of the transmission. That way, you can be sure that your transmission is running smoothly and efficiently. If your car has a 4L60E transmission, it’s important to keep the fluid and filter fresh. So if you haven’t changed your fluid in awhile, now might be a good time to do so! 4L60E Transmission Fluid And Filter Change For example, if your car has an aftermarket pan or filter, then it might hold less fluid.Īdditionally, the amount of fluid your transmission needs will depend on whether you’re doing a flush or simply a drain and fill.Ī flush will require more fluid, as all of the old fluid will need to be removed from the system.įinally, it’s important to note that most manufacturers recommend changing your transmission fluid every 50,000 miles or so. However, there are a few things that can affect this number. The short answer is that the 4L60E transmission holds approximately 11 quarts of fluid. If you own a car with an 4L60E transmission, then at some point you’re going to have to change the fluid. It is important to check your owner’s manual or service manual to verify the correct type of fluid for your specific vehicle. The recommended type of transmission fluid for the 4L60E is Dexron III/Mercon, although some newer vehicles may require Dexron VI/Mercon LV fluids. The transmission fluid capacity varies depending on the vehicle application, but it is typically around 12 quarts (11 liters). ![]() It is available in both two-wheel drive and four-wheel drive applications. The 4L60E has a maximum torque capacity of 360 lb-ft and is capable of handling engines with up to 415 horsepower. Another significant change was the switch from a hydraulic to an electric pump, which provided more precise control over fluid pressure. This not only made the transmission more responsive, but it also reduced wear and tear on the internal components. One of the most important changes was the addition of an electronic control unit (ECU) that controlled shift points and torque converter lockup. The 4L60E shared many design features with its predecessor, but it also incorporated several new technologies that greatly improved its performance and reliability. The 4L60E is the successor to the Turbo Hydramatic 700R4 and was originally introduced in 1992 as an upgrade. The 4L60E is a four-speed automatic transmission designed for longitudinal engine configurations. 4L60E Transmission Fluid Capacity And Type If you’re low on fluid, your transmission may not shift properly or may even slip. It’s important to keep your transmission fluid level topped off so that your transmission can work properly. The 4L60E is a popular automatic transmission that’s often used in GM vehicles. If you have a 4L60E transmission, you’ll need about 9 quarts of fluid to fill it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |